Safety Belt Retractor - Front

SAFETY BELT RETRACTOR - FRONT







Removal and Installation

WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.

The automatic locking retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR feature for a child safety seat is functioning correctly, in addition to other checks for correct safety belt system function. A new belt and retractor assembly must be installed if the safety belt assembly's ALR feature, or any other safety belt function, is not operating correctly when inspected according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase the risk of injury in collisions.

1. NOTE: Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed, install a new D-ring cover.

Remove the upper and lower B-pillar trim panels.

2. Release the 2 pin-type retainers and safety belt guide.
3. Remove the bolt and safety belt retractor.
- To install, tighten to 40 Nm (30 lb-ft).

4. NOTE:
- Make sure the safety belt webbing is not twisted prior to installation.
- When installing the safety belt retractor, make sure to engage the anti-rotation tab to the sheet metal
- Remove the shipping clip after safety belt retractor installation.

To install, reverse the removal procedure.

5. Check the active restraint system for correct operation.