Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2007 >> Expedition 4WD V8-5.4L >> Repair and Diagnosis >> Starting and Charging >> Starting System >> Starter Motor >> Testing and Inspection >> Starter Motor - Load Test
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Starter Motor - Load Test

STARTER MOTOR - LOAD TEST

WARNING: When servicing the starter motor or carrying out other underhood work in the vicinity of the starter motor, be aware that the heavy gauge battery input lead at the starter solenoid is "electrically hot" at all times. Failure to follow these instructions may result in personal injury.

CAUTION: A protective cap or boot is provided over the battery input terminal on all car lines and must be installed after repair. Be sure to disconnect the battery ground cable before repairing the starter motor.

1. Before carrying out this test inspection, check the battery to determine its state of charge. Carry out a load test of the battery using the Starter, Alternator, Battery, Regulator and Electrical (SABRE) Tester. Refer to Charging System for the test procedure.
2. Disconnect the ignition coil connector from the ignition coil.
3. Connect the SABRE tester to the vehicle using the amperage lead clipped around the positive battery cable.
4. Measure the amperage of the starter motor while activating the starting system.
5. A correctly operating starter motor will draw from 130 to 190 amps of current at room temperature.
pro multis · About Operation CHARM