Trailing Arm - Lower

Trailing Arm - Lower





Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

CAUTION: Do not tighten the lower trailing arm-to-frame bolt until the installation procedure is complete and the weight of the vehicle is resting on the wheel and tire assemblies.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the 2 lower trailing arm-to-wheel knuckle bolts.
^ To install, tighten to 103 Nm (76 lb-ft).
3. Remove and discard the lower trailing arm-to-frame bolt and flagnut.
^ To install, tighten to 275 Nm (203 lb-ft).
4. Remove the lower trailing arm.

5. CAUTION: Do not tighten the lower trailing arm-to-frame bolt until the installation procedure is complete and the weight of the vehicle is resting on the wheel and tire assemblies.

To install, reverse the removal procedure.