Selector Lever Bezel
Selector Lever BezelVehicles Equipped With a 6R75 Transmission:
Vehicles Equipped With a 6HP26 Transmission:
Removal
All vehicles
1. NOTE: 6R75 transmission selector lever shown, 6HP26 similar.
Remove the PRNDL trim, console tray and cup holder insert.
2. Remove the screw and the console upper trim.
3. Remove and discard the RH selector lever knob cover.
1 Start at the bottom rear only.
2 Work towards the top.
4. Remove and discard the LH selector lever knob cover.
1 Start at the bottom rear only.
2 Work towards the top.
5. Remove and discard the RH selector lever knob screw.
6. Remove and discard the LH selector lever knob screw.
7. Disconnect the transmission control (TC) switch electrical connector and remove the selector lever knob.
8. Lift the tabs on the selector lever bezel and lift the bezel for access to the electrical harness.
9. Disconnect the electrical harness from the selector lever housing.
Vehicles equipped with a 6R75 transmission
10. Disconnect the electrical harness from the bezel.
Installation
Vehicles equipped with a 6R75 transmission
1. Connect the electrical harness onto the bezel.
All vehicles
2. Connect the electrical harness onto the selector lever housing.
3. Align the brake shift interlock override tab into its guide.
4. Install the selector lever bezel onto the selector lever housing.
5. Connect the transmission control (TC) switch electrical connector and install the selector lever knob.
6. Install a new LH selector lever knob screw.
^ tighten to 2 Nm (18 lb-in).
7. Install a new RH selector lever knob screw.
^ Tighten to 2 Nm (18 lb-in).
8. NOTE: Wood trimmed vehicles have a rubber damper not found on other trim levels.
Install a new LH selector lever knob cover.
9. NOTE: Wood trimmed vehicles have a rubber damper not found on other trim levels.
Install a new RH selector lever knob cover.
10. Install the console upper trim and the screw.
11. Install the PRNDL trim, console tray and cup holder insert.
12. Verify brake shift interlock function.