Selector Lever Knob

Selector Lever Knob

Selector Lever Knob:

Removal
1. Remove the front floor console. For additional information, refer to Console.
2. Disconnect the transmission control (TC) switch electrical connector and feed the wire through the selector lever housing.





3. Slide the selector lever lower trim cover downward.





4. Remove the set screw and remove the selector lever knob while routing the TC switch harness out of the selector lever housing.





Installation

1. CAUTION: Do not overtighten the set screw or damage to the selector lever knob may occur.

Install the selector lever knob and set screw while routing the TC switch harness through the selector lever housing.
^ Tighten to 3 Nm (27 inch lbs.)





2. Slide the selector lever lower trim cover upward.





3. Feed the wire through the selector lever housing and connect the TC switch electrical connector.





4. Install the front floor console. For additional information, refer to Console.