Pedal Positioning Motor: Service and Repair

Brake Pedal Motor

Brake Pedal Motor:

Removal and Installation
1. Disconnect the accelerator and brake pedal drive cables from the adjustable pedal motor.
2. Disconnect the adjustable pedal motor electrical connector.
3. Remove the 2 adjustable pedal motor screws and then remove the adjustable pedal motor and drive cables as an assembly.
^ To install, tighten to 3 Nm (27 inch lbs.).

4. NOTE: Make sure the brake pedal and the accelerator pedal are in the same position before connecting the drive cable to the adjustable pedals.

To install, reverse the removal procedure.