Electronic Brake Control Module: Service and Repair

REMOVAL AND INSTALLATION

Anti-Lock Brake System (ABS) Module





Removal and Installation

CAUTION: Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to the charges.

CAUTION: When installing a new ABS module or hydraulic control unit (HCU), do not use the pump motor harness as a carrying handle. Failure to follow these instructions may result in damage to the HCU assembly.

All vehicles
1. Disconnect the battery ground cable.

Vehicles equipped with 5.4L engine.
2. Remove the air cleaner intake pipe.

All vehicles
3. Disconnect the ABS module electrical connector.
4. Remove the 4 screws and the ABS module.
^ To install, tighten to 3 Nm (27 inch lbs.).

5. NOTE: The ABS module is not repairable. If an internal problem exists, a new part must be installed.

To install, reverse the removal procedure.
^ When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the scan tool directions for calibration procedures.