Audio Unit Self-Diagnostic Test

AUDIO UNIT SELF-DIAGNOSTIC TEST

NOTE: The audio unit self-diagnostic test disables the DVD player buttons. Turning the ignition switch off and back on may not re-enable the DVD player buttons. To re-enable the DVD player buttons, turn the audio unit off and back on. The headphone symbol lights up on the audio unit display to indicate the DVD player buttons are re-enabled.

1. To enter the following tests, press the desired preset button while in the speaker walk-around test or while in the audio unit self-diagnostic test.
2. To exit the audio unit self-diagnostic test, turn the ignition switch or the audio unit off.
3. The self-diagnostic test has 7 manual tests available:
- Preset button 1 = Audio internal/external tests. This test verifies the communication to devices internal and external to the audio system. While the tests are carried out, the display flashes SELF TEST. When the tests are completed, the display stops flashing and shows either SELF PASS or SELF FAIL. Failures can be viewed by pressing the tune up button to start the scroll through the list of faults. Each fault is displayed for 2 seconds. After the last fault is displayed, SELF FAIL is returned to the display.

Internal/external self-test can be exited anytime by entering another diagnostic test.

- Preset button 2 = VIEW/CLEAR DTCs. This test displays and allows the diagnostic trouble codes (DTCs) to be cleared. If no DTCs are found, the display shows NO DTCs. If any DTCs are present, the display shows DTCS FOUND and can be viewed by pressing the tune up button to start scrolling through the list of faults.

To clear all DTCs, press the EJECT key. The display shows DTCS CLEAR.

- Preset button 3 = SIGNAL STRENGTH TEST. This test displays the average signal strength of the currently tuned frequency.
- Preset button 4 = Software version information. This test queries each radio system controller for its software version information. The software levels can be viewed by pressing the tune up button to start scrolling the various microcontrollers. After the last software level is displayed, the SOFT LEVELS message is returned to the display.
- Preset button 5 = DISPLAY TEST. This test lights all the display segments for 5 seconds and then turns all segments off.
- Preset button 6 = MODULE CONFIGURATION. This tests the audio unit configuration. The configuration can be viewed by pressing the tune up button.
- CD button = CDX6 diagnostic mode. This test displays the last modes and errors that are saved in the memory. While these tests are being carried out, the audio unit displays CD DIAG. The modes and errors can be viewed by pressing the tune up button.

4. To exit the self-diagnostic test, turn the key to OFF or turn the audio unit off.
5. If the concern remains and the fault is not detected, GO to Symptom Chart. Symptom Related Diagnostic Procedures