Evaporative Emission System

EVAPORATIVE EMISSIONS

The evaporative emission system:
- is equipped with an on-board refueling vapor recovery (ORVR) system.
- prevents hydrocarbon emissions from reaching the atmosphere.
- stores fuel vapors in the evaporative emission (EVAP) canister that are generated during vehicle operation hot soak or vehicle refueling, until they can be consumed by the engine during normal engine operation.
- routes the stored fuel vapors to the engine during engine operation.
- is controlled by the powertrain control module (PCM) which, using various sensor inputs, calculates the desired amount of EVAP purge flow. The PCM regulates the purge flow, induced by the application of intake manifold vacuum, by varying the current applied to the canister purge valve.

The fuel vapors are routed:
- from the fuel tank through the fill limit valve and fuel vapor vent valve.
- to the EVAP canister(s) through a vapor tube.
- to the engine when the EVAP canister purge valve is opened by the PCM.

The EVAP canister:
- is located under the rear of the vehicle.
- contains activated carbon.
- stores fuel vapors.

The fuel tank filler cap:
- relieves system vacuum below 3.8 kPa (15.26 inches H2O).

The EVAP canister vent solenoid:
- is normally open.
- seals the EVAP system for the inspection and maintenance (I/M 240) test and OBD II leak and pressure tests.
- is mounted to the EVAP canister bracket.
- is serviced as a separate item.

The EVAP canister purge valve:
- is normally closed.
- regulates the purging of the EVAP canister.
- is controlled by the PCM.

The fuel tank pressure transducer (FTPT) (part of the fuel vapor tube assembly):
- monitors the pressure levels in the vapor tube at the fuel tank vapor outlet.
- communicates the pressure reading to the PCM during the OBDII leak test.
- is located in and is serviced as part of the fuel vapor tube assembly.

The EVAP system monitor:
- is a self-test strategy within the PCM which tests the integrity of the EVAP system.
- monitors the EVAP system for leaks.
- monitors electronic EVAP components for irrationally high or low voltages.
- monitors for correct EVAP system operation.
- uses negative and positive leak test methods to test and activate the EVAP system.

The EVAP Running Loss System Leak Test:
- utilizes intake manifold vacuum to test the system and involves several stages.