Overhaul

Selector Lever

Material:

Disassembly

1. NOTE: Use vise jaw protectors for all work to be done in the vise.

Disconnect the overdrive (O/D) switch electrical connector.





2. Remove the selector lever knob.
^ Remove and discard the screw.





3. Disassemble the selector lever.
^ Pull off the tappet.
^ Unclip the bezel.





Assembly

CAUTION: When installing the selector lever knob, make sure the wiring harness is positioned forward and is centered on the shift lever shaft, or damage to the shift lever or wiring harness will occur.

1. To assemble, reverse the disassembly procedure.
^ Coat all sliding and turning parts with grease.
^ Install a new selector lever knob screw.