Throttle Body: Service and Repair

THROTTLE BODY







Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.







3. Remove the bolt and the snow shield.
- To install, tighten to 10 Nm (89 lb-in).

4. Disconnect the throttle position (TP) sensor electrical connector.







5. Disconnect the accelerator cable, the speed control cable and the return spring.
6. Remove the 3 bolts, the stud bolt and the throttle body (TB).
- Discard the TB gasket.
- To install, tighten to 10 Nm (89 lb-in).

7. If servicing the TB, remove the TP sensor.

8. NOTE: Clean all TB sealing surfaces and install a new TB gasket.

To install, reverse the removal procedure.