Ignition Coil Pack: Service and Repair

IGNITION COIL PACK







Exploded View

Removal and Installation
1. Disconnect the ignition coil electrical connector.

2. CAUTION: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.

Disconnect the spark plug wires by twisting while pulling upward.







3. Disconnect the heater hose support from the stud.
4. Remove the 2 bolts, the stud bolt and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

5. To install, reverse the removal procedure.
- Use a small, clean tool to coat the entire interior surface of the boot with silicone brake caliper grease.