Base AM/FM Audio Unit

SPEAKER WALK-AROUND TEST - BASE AM/FM AUDIO UNIT

NOTE: The audio unit must be turned on to enter the speaker walk-around test.

1. To enter the test, press and hold preset buttons 3 and 6 simultaneously for approximately 3 seconds, then release.
2. The test applies sound to each speaker for 1-2 seconds. Speakers are tested in the following sequence: RH, LH.
3. To exit the test, turn the key to OFF or turn the audio unit off.
4. If the concern remains and the fault is not detected, GO to Symptom Chart. Symptom Related Diagnostic Procedures