Seat Backrest - Front, 60 Percent
SEAT BACKREST - FRONT, 60 PERCENTSeat Backrest, Front, 40 Percent:
Seat Backrest, Front, 60 Percent:
Seat Cushion, Front, 60 Percent (Part 2):
Seat Cushion, Driver, 40 Percent (Part 1):
Seat Cushion, Driver, 40 Percent (Part 2):
Seat Cushion, Front Passenger (Part 1):
Seat Cushion, Front Passenger (Part 2):
Seat Armrest, Front, 60 Percent:
Exploded View
Removal
All seats
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the supplemental restraint system (SRS).
2. Remove the 60 percent bench seat.
3. Remove the 60 percent bench armrest.
4. Remove the backrest recliner handle screw and the handle.
5. Remove the 2 side shield screws.
6. Pull out on the side and the rear of the side shield to detach the 2 clips (1 shown).
7. Remove the outboard recliner cable anchor and swivel and detach the recliner cable end.
8. Remove the outboard pin-type retainer and position the material aside.
9. Remove the 2 outboard backrest-to-cushion bolts.
10. Remove the inboard seat backrest latch release cable anchor and swivel and detach the cable end.
11. Remove the front inboard backrest-to-cushion bolt.
SuperCab seat
12. Remove the inboard rear bolt cover.
All seats
13. Remove the inboard rear backrest-to-cushion bolt.
14. Remove the backrest assembly.
Installation
All seats
1. Install the backrest assembly.
2. Install the inboard rear backrest-to-cushion bolt.
- Tighten to 25 Nm (18 lb-ft)
SuperCab seat
3. Install the inboard rear bolt cover.
All seats
4. Install the inboard front backrest-to-cushion bolt.
- Tighten to 25 Nm (18 lb-ft).
5. Install the inboard seat backrest latch release cable end and swivel and install the cable anchor.
6. Install the 2 outboard backrest-to-cushion bolts.
- Tighten to 25 Nm (18 lb-ft).
7. Position the trim cover material and install the outboard pin-type retainer.
8. Install the outboard seat backrest Latch release cable end and swivel and install the cable anchor.
9. Position the side shield and install the 2 clips (1 shown).
10. Install the 2 side shield screws.
11. Install the backrest recliner handle and screw.
12. Install the 60 percent bench armrest.
13. Install the 60 percent bench seat.
14. Repower the SRS.