Seat - Front

SEAT - FRONT

60 Percent Seat:

40 Percent Seat:

Removal

WARNING: The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Depower the SRS.
2. Position the seat fully forward.

60 percent seat







3. Release and pull the front safety belt bolt cover upward on the safety belt, if equipped.
4. Remove the center safety belt bolt.

All seats
5. Remove the 2 rear seat-to-floor bolts.
6. Position the seat fully rearward.
7. Remove the 2 front seat-to-floor bolts.

60 percent seat







8. NOTE: The SuperCab and regular cab safety belts route differently. Note belt position for correct installation.

Route the center safety belt buckle through the locating strap on the side of the seat.

All seats
9. Disconnect the electrical connector and remove the seat.

Installation

NOTE: The seat track-to-floor bolts must be tightened in the sequence described in this procedure.

All seats
1. Position the seat in the vehicle.
2. Connect the seat electrical connector.

60 percent seat







3. NOTE: SuperCab and regular cab safety belts route differently, make sure of correct routing.

Position the seat fully forward and route the center safety belt buckle through the locating strap on the side of the seat.

4. Install the safety belt bolt.
- Tighten to 55 Nm (41 lb-ft)







5. Slide the safety belt bolt cover on the safety belt and position in place, if equipped.

All seats
6. Position the seat fully rearward and install the front inboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft)

7. Install the front outboard seat-to-floor bolt
- Tighten to 55 Nm (41 lb-ft)

8. Position the seat fully forward and install the rear inboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft)

9. Install the rear outboard seat-to-floor bolt.
- Tighten to 55 Nm (41 lb-ft)
- Make sure the safety belts and buckles are accessible to the occupants after installation.

10. Repower the SRS.