Part 2
EngineInstallation (Steps 26-50)
26. Position the engine ground wire and install the nut.
^ Tighten to 10 Nm (89 inch lbs).
27. Connect the 2 engine wiring harness electrical connectors.
28. Position the wiring harness and install the bolt.
^ Tighten to 10 Nm (89 inch lbs).
29. Connect the generator wiring.
^ Tighten to 8 Nm (71 inch lbs).
30. Position the accessory bracket, the A/C compressor if equipped, and the power steering pump and power steering fluid reservoir as an assembly and install the accessory bracket bolts.
^ Tighten to 42 Nm (31 ft. lbs).
31. NOTE: The battery is removed for clarity.
Connect the power steering return hose to the power steering fluid reservoir.
32. Connect the power steering high pressure hose to the lower power steering pump fitting.
33. If equipped with A/C, position the A/C compressor manifold tube and install the bolt.
^ Tighten to 20 Nm (15 ft. lbs).
34. If equipped with A/C connect the A/C high pressure switch electrical connector.
35. If equipped with A/C, connect the A/C field coil electrical connector.
36. Install the accessory drive belt.
37. NOTE: Do not fill the cooling system at this time.
Install the radiator.
38. Install the air cleaner housing cover.
39. Connect the mass air flow (MAF) sensor.
40. Install the fan blade.
41. Install the hood.
42. Position the RH spark plug wires and attach the retainer to the RH valve cover stud. Coat the inside of the spark plug wire boots with Silicone Brake Caliper Grease and Dielectric Compound and connect the spark plug wires to the correct spark plugs.
43. Position the ignition coil, the bracket and the LH spark plug wires and attach the spark plug wire retainer to the LH vale cover stud. Coat the inside of the spark plug wire boots with Silicone Brake Caliper Grease and Dielectric Compound and connect the spark plug wires to the correct spark plugs.
44. Connect the fuel tube spring lock couplings. For additional information, refer to Fuel Delivery and Air Induction.
45. Install the intake manifold.
46. Connect the battery ground cable. For additional information, refer to Battery.
47. Fill the engine to the correct oil level with clean engine oil.
48. Fill the engine cooling system.
49. Fill the power steering system.
50. If equipped with A/C, recharge the A/C system. For additional information, refer to Heating and Air Conditioning.