Throttle Position Sensor: Service and Repair

THROTTLE POSITION (TP) SENSOR







Removal and Installation







1. Remove the accelerator control snow shield.
2. Disconnect the throttle position (TP) sensor electrical connector.

3. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1 to 2 full turns using a hand tool, and then use a suitable high speed driver to complete the removal.

Remove and discard the 2 bolts and the TP sensor.
- To install, tighten to 3 Nm (27 lb-in).

4. CAUTION:
- Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
- Do not use a high speed driver to install the new screws or damage to the TP sensor can occur.

NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body (TB).

To install, reverse the removal procedure.
- Install a new TP sensor and screws.