Ignition Coil Pack: Service and Repair

IGNITION COIL PACK







Exploded View

Removal and Installation
1. Disconnect the battery ground cable.
2. Disconnect the ignition coil electrical connector.

3. CAUTION:
- It is important to twist the spark plug wire boots while pulling upward, to avoid possible damage to the spark plug wire.
- Spark plug wires must be connected to the correct ignition coil terminal.

Squeeze the locking tabs and twist while pulling upward, to disconnect the 6 spark plug wires from the ignition coil.

4. Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

5. NOTE:
- Apply silicone dielectric compound to the inside of the spark plug wire coil boots.
- Be sure to reinstall the radio ignition interference capacitor under the correct ignition coil mounting bolt.

To install, reverse the removal procedure.