Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor

Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the output shaft speed (OSS) sensor electrical connector.





3. Remove the OSS sensor.
1. Remove the OSS sensor screw.
2. Remove the OSS sensor from the transmission.





Installation

1. NOTE: Inspect the OSS sensor O-ring for damage. If damaged, install a new O-ring.

Inspect and lubricate the O-ring with petroleum jelly.
1. Install the OSS sensor into the transmission.
2. Install the OSS sensor screw.
^ Tighten to 10 Nm (89 inch lbs.)





2. Connect the OSS sensor electrical connector.