Wiper Switch: Service and Repair

Steering Column Multifunction Switch

Steering Column Multifunction Switch:

Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. If equipped, remove the tilt release lever/ handle.
4. Remove the 3 steering column cover screws and upper and lower steering column shrouds.
5. Disconnect the multi-function switch electrical connectors.
6. Remove the 2 multi-function switch screws and the multi-function switch.
^ To install, tighten to 3 Nm (27 inch lbs.)
7. To install, reverse the removal procedure.