Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley

Lower End Components - Exploded View:

Special Tool(s):

Material:

Removal
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the air cleaner outlet tube. For additional information, refer to Fuel Delivery and Air Induction.
3. Remove the fan blade and the fan shroud. For additional information, refer to Cooling System.
4. Remove the accessory drive belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
5. Remove the 4 bolts and the crankshaft pulley.
6. Remove the crankshaft bolt and the washer.
7. Using the special tool, remove the crankshaft damper.





8. Remove the crankshaft key, if necessary.





Installation

1. NOTE: Apply a drop of silicone gasket and sealant, securing crankshaft key in position.

If removed, install the crankshaft key.





2. Using the special tool, install the crankshaft damper.
^ Coat the sealing surfaces of the crankshaft damper with clean engine oil.
^ Coat the crankshaft damper keyway with silicone gasket and sealant.
^ Install the crankshaft damper.





3. Install the crankshaft bolt and the washer.
^ Tighten to 145 Nm (107 ft. lbs).
4. Install the crankshaft pulley and 4 bolts.
^ Tighten to 63 Nm (46 ft. lbs).
5. Install the drive belt.
6. Install the fan blade and the fan shroud.
7. Install the air cleaner outlet tube. For additional information, refer to Fuel Delivery and Air Induction.
8. Connect the battery ground cable. For additional information, refer to Battery.