Shift Cable: Service and Repair
Selector Lever Cable and BracketSelector Lever Cable and Bracket (Part 1):
Selector Lever Cable and Bracket (Part 2):
Removal and Installation
1. Disconnect the transmission selector lever cable from the steering column.
1. Disconnect the selector lever cable from the transmission column shift selector tube.
2. Disconnect the selector lever cable from the steering column bracket.
2. Push the rubber grommet and selector lever cable through the bulkhead.
3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
4. Disconnect the selector lever cable from the locking clip.
5. Remove the transmission selector lever cable from the manual lever.
6. Remove the selector lever cable clip and remove the cable from the bracket.
7. Remove the transmission selector lever cable bracket from the automatic transmission.
8. To install, reverse the removal procedure.
^ Tighten to 40 Nm (30 ft. lbs.)
^ Move manual lever into the OVERDRIVE position.
^ Adjust the transmission selector lever cable.
