4R70E/4R75E - Automatic Transaxle/Transmission

Digital Transmission Range (TR) Sensor

Digital Transmission Range (TR) Sensor:

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the digital transmission range (TR) sensor electrical connector.
3. Disconnect the selector lever cable from the manual control lever.





4. Remove the manual control lever.
1) Remove the manual control lever outer nut.
2) Remove the manual control lever.





5. Remove the digital TR sensor bolts and sensor.





Installation
1. Loosely install the digital TR sensor bolts and sensor.





2. NOTE: The manual shift lever must be in the NEUTRAL position.

Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.





3. CAUTION: Tightening one screw before tightening the other may cause the digital TR sensor to bind or become damaged.

Tighten the digital TR sensor bolts.
^ Tighten to 9 Nm (80 lb-inch).





4. Install the manual control lever.
1) Position the manual control lever.
2) Install a new manual control lever outer nut.
^ Tighten to 33 Nm (24 lb-ft).





5. Connect the selector lever cable end to the manual control lever with the manual control lever in the NEUTRAL position.





6. Install the digital TR sensor electrical connector.