Universal Serial Bus (USB) Cable and Port

UNIVERSAL SERIAL BUS (USB) CABLE AND PORT

Universal Serial Bus (USB) Cable-To-Accessory Protocol Interface Module (APIM):

Universal Serial Bus (USB)-To-Accessory Protocol Interface Module (APIM):

Removal and Installation
1. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
2. Disconnect the universal serial bus (USB) cable-to-accessory protocol interface module (APIM) connector.
3. Remove the floor console upper trim panel by pulling straight up to disengage the clips.
4. Disconnect the USB cable-to-bezel connector, and remove the USB cable and port.
- Disengage the push-type retainers.

5. To install, reverse the removal procedure.