Test E: The Roof Opening Panel Does Not Open Or Close

PINPOINT TEST E: THE ROOF OPENING PANEL DOES NOT OPEN OR CLOSE

The roof opening sliding glass panel motor/module must be initialized whenever the roof opening sliding glass panel motor/module has been removed from the roof opening panel system, a new roof opening sliding glass panel motor/module has been installed or a new roof opening panel module assembly has been installed. Refer to Roof Opening Panel Motor Initialization. Programming and Relearning

Normal Operation
The roof opening panel uses an integrated motor and module to operate the roof opening panel sliding glass.

The roof opening sliding glass panel motor/module receives voltage from the accessory delay relay through circuit CBP41 (BU) when the key is in the ACC or RUN position and voltage at all times through circuit SBB18 (YE/RD). Ground is supplied to the roof opening sliding glass panel motor/module through circuit GD133 (BK). The roof opening panel switch receives ground from the roof opening panel motor/module assembly through circuit GD133 (BK). When the roof opening panel open switch is pressed, the roof opening panel switch grounds circuit CPR31 (VT/BN) and the roof opening sliding glass panel motor/module opens the roof opening panel sliding glass. When the roof opening panel close switch is pressed, the roof opening panel switch grounds circuit CPR40 (YE/OG) and the roof opening sliding glass panel motor/module closes the roof opening panel sliding glass.

This pinpoint test is intended to diagnose the following:
- Fuse(s)
- Wiring, terminals or connectors
- Roof opening panel switch
- Roof opening sliding glass panel motor/module
- Accessory delay relay
- Roof opening sliding glass panel motor not initialized

E1-E5:

E5-E6:

E7-E9:

E9-E10: