Seat Cushion - Front
SEAT CUSHION - FRONTExploded View
Front Seat Backrest, Manual and Power Recline, Without Fold Flat (Part 1):
Front Seat Backrest, Manual and Power Recline, Without Fold Flat (Part 2):
Front Seat Backrest, Manual Recline With Fold Flat (Part 1):
Front Seat Backrest, Manual Recline With Fold Flat (Part 2):
Seat Cushion With Power Seat Track (Part 1):
Seat Cushion With Power Seat Track (Part 2):
Driver Seat Cushion With Manual Seat Track (Part 1):
Driver Seat Cushion With Manual Seat Track (Part 2):
Passenger Seat Cushion With Manual Seat Track:
Passenger Power Seat Track (Part 1):
Passenger Power Seat Track (Part 2):
Special Tool(s)
Special Tool(s):
Removal
WARNING: Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat.
2. Release all wire harness and connector retainers to the cushion frame.
Passenger seat with fold-flat backrest
3. Separate the fold-flat recliner cable holders from the bottom of the cushion frame.
Seats with climate control
4. Disconnect the cushion thermo-electric device (TED).
Passenger seat with manual track and heat
5. Disconnect the heated seat module electrical connector and separate the pin-type retainers from the cushion frame.
Seats with heat
6. Disconnect the 2 heated seat electrical connectors and separate the pin-type retainers from the cushion frame.
All seats
7. Remove the 4 cushion frame-to-seat track bolts and the cushion assembly.
Installation
Passenger seat with fold-flat backrest
1. Make sure the fold-flat recliner cable is routed correctly between the power seat track cross tube and cushion frame.
All seats
2. Position the cushion assembly and install the 4 cushion frame-to-seat track bolts.
- With power seat track, make sure the cushion frame-to-seat track rear brackets are aligned correctly with the tabs seated in the cushion frame (if equipped).
- Tighten to 23 Nm (17 lb-ft).
All passenger seats
3. For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing - Front Passenger Cushion.
Passenger seat with fold-flat backrest
4. Attach the 2 fold-flat recliner cable holders to the bottom of the cushion frame.
Seats with heat
5. Route the heated seat wire harness, connect the 2 heated seat electrical connectors and attach the pin-type retainers to the cushion frame.
Passenger seat with manual track and heat
6. Connect the heated seat module electrical connector and attach the pin-type retainers to the cushion frame.
Seats with climate control
7. Connect the cushion TED.
All seats
8. Attach any remaining wire harness and connector retainers to the cushion frame.
9. Install the front seat. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
10. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test.