Manual

LUMBAR ASSEMBLY - MANUAL

Exploded View

Front Seat Backrest, Manual and Power Recline, Without Fold Flat (Part 1):

Front Seat Backrest, Manual and Power Recline, Without Fold Flat (Part 2):

Front Seat Backrest, Manual Recline With Fold Flat (Part 1):

Front Seat Backrest, Manual Recline With Fold Flat (Part 2):

Seat Cushion With Power Seat Track (Part 1):

Seat Cushion With Power Seat Track (Part 2):

Driver Seat Cushion With Manual Seat Track (Part 1):

Driver Seat Cushion With Manual Seat Track (Part 2):

Passenger Seat Cushion With Manual Seat Track:

Passenger Power Seat Track (Part 1):

Passenger Power Seat Track (Part 2):

Special Tool(s)

Special Tool(s):

Removal and Installation

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Remove the front seat.
2. Remove the cushion side shield in the following sequence.
1 If equipped with manual recline, release the clip and remove the manual recline handle.
2 If equipped with manual height adjust, pull and remove the manual height adjust handle.

3 NOTE: Release the tension on the manual lumbar cable before removing the manual lumbar handle.

Release the 2 clips on the back of the manual lumbar handle then pull and remove the manual lumbar handle.

4 Remove the cushion side shield screw(s).
5 If equipped with power seat track, slide the cushion side shield up in the rear to release the retainer.
6 Slide the cushion side shield forward to disengage the retainer.
- If equipped with manual seat tracks, remove the cushion side shield.

7 If equipped with power seat tracks, disconnect the seat control switch electrical connector.
- Remove the cushion side shield.

3. Remove the lumbar cable from the manual lumbar adjuster in the following sequence.
1 Remove the manual lumbar adjuster to bracket screw.
2 Separate the manual lumbar adjuster from the bracket.
3 Remove the lumbar cable from the manual lumbar adjuster.

4. NOTE: The seat backrest trim cover and foam pad have been removed to show the backrest trim panel retainers.

Remove the backrest trim panel in the following sequence.
1 Release the 2 pin-type retainers at the bottom of the backrest trim panel.
2 Slide the backrest trim panel down to release the upper clips.
3 Turn the backrest trim panel to release the middle clips and remove the backrest trim panel.







5. NOTE: Lower outer J-clips are unfastened to show inner J-clips.

Release the backrest trim cover outer and inner J-clips attached to the backrest frame.







6. Release the manual lumbar hooks from the backrest frame, route out the manual lumbar cable and remove the manual lumbar assembly.
7. To install, reverse the removal procedure.
8. Install the front seat. If a passenger seat has been serviced, do not prove out the SRS at this time.

Passenger seat
9. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test.