Sunroof / Moonroof Weatherstrip: Service and Repair

ROOF OPENING PANEL SEAL - PRIMARY

Exploded View

Exterior Trim, Seals, Fixed Glass and End Caps:

Air Deflector Assembly:

Sliding Glass, Blinds and Primary Seal:

Idler Track and Mechanism:

Front and Rear Sunshade Assembly:

Rear Trim Ring Assembly:

Roof Opening Panel Motor(s) and Electrical:

Motor Block and Drive Tube Assembly:

Guide Tracks and Mechanisms:

Front Guide Track Mechanism:

Removal
1. Remove the roof opening panel sliding glass.
2. Carefully peel off the primary seal.
- Clean residual adhesive tape from the housing using a suitable cleaner.

Installation

Primary Seal Alignment:

1. NOTE:
- The primary seal seam is placed at the rear centerline.
- Make sure the primary seal lip is facing outward.

Install the primary seal.

2. NOTE: When the roof opening sliding glass panel is in the VENT position, the roof opening panel primary seal should contact the leading edge of the sliding glass.

Install the roof opening panel sliding glass.
- Initialize the roof opening panel motor(s). For additional information, refer to Roof Opening Panel Motor Initialization. Programming and Relearning