Brake Disc Removal and Installation, Rear

Brake Disc

Material:

Removal
1. Remove the wheel and tire.

2. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^ Support the brake caliper and anchor plate assembly using mechanic's wire.
3. Remove the brake disc.

Installation
1. Clean and dry the brake disc-to-hub mounting surface and apply a thin coat of anti-seize lubricant where indicated.





2. Install the brake disc onto the wheel hub.
3. Position the brake caliper and anchor plate assembly and install the 2 brake caliper anchor plate bolts.
^ Tighten to 90 Nm (66 lb-ft).
4. Install the wheel and tire.
^ Apply brakes several times to verify correct brake operation.