Cylinder Head Distortion
Cylinder Head DistortionSpecial Tool(s):
NOTE: Refer to the specifications at the component.
1. NOTE: Make sure all cylinder head surfaces are clear of any gasket material, RTV, oil and coolant. The cylinder head surface must be clean and dry before running a flatness check.
NOTE: Use a straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On(R) GA438A or equivalent. For example, if the straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.
Using a straightedge and a feeler gauge, inspect the cylinder head for flatness in the sequence shown.
