Ignition Switch: Service and Repair

Ignition Switch

Ignition Switch (Part 1):

Ignition Switch (Part 2):

Removal and Installation
1. Depower the supplemental restraints system (SRS). For additional information, refer to Air Bag Systems.

2. NOTE: Release the upper steering column shroud by pressing inward on the sides and lifting upwards.

Remove the upper steering column shroud.
3. Release the tilt lever, remove the 3 lower steering column shroud screws and the shroud.

4. NOTE: The top of the steering column opening cover is held in by tabs that clip into the instrument panel.

Remove the 2 steering column opening cover screws.
^ Detach the steering column opening cover by pulling straight outward.
5. If equipped, disconnect the electrical connector and hose from the in-vehicle temperature sensor.
^ Remove the steering column opening cover.
6. Disconnect the ignition switch electrical connector.
7. Press the 2 locking tabs and remove the ignition switch.
8. To install, reverse the removal procedure.
9. Repower the SRS. For additional information, refer to Air Bag Systems.