Rear Door Window Regulator: Service and Repair

WINDOW REGULATOR - REAR DOOR

Exploded View

Part 1:

Part 2:

Removal and Installation
1. Remove the rear door trim panel.
2. Remove the screw and the rear door trim panel bracket.







3. Position the watershield aside.
4. Connect the window control switch electrical connector.
5. Using the window control switch, lower the rear door window glass to gain access to the rear door window glass screws.
6. Disconnect the window control switch electrical connector.
7. Remove the 2 rear door window glass screws.
- To install, tighten to 5 Nm (44 lb-in).







8. Support the rear door window glass in the full up position with tape.
9. Disconnect the rear door window motor electrical connector.
10. Remove the rear door window regulator and motor bolt.
- To install, tighten to 11 Nm (8 lb-ft).







11. Loosen the 2 rear door window regulator and motor bolts.
- To install, tighten to 11 Nm (8 lb-ft).







12. Remove the 2 nuts and the rear door window regulator and motor.
- To install, tighten to 6 Nm (53 lb-in).







13. To install, reverse the removal procedure.