Rear

Brake Pads

Disc Brake System - Exploded View:

Removal and Installation

CAUTION: Do not allow brake fluid to overflow from the master cylinder reservoir. Brake fluid may damage the high-voltage components.

NOTE: The rear brake pads will wear at approximately twice the rate of the front brake pads.

1. Remove the wheel and tire.

2. NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.

Disconnect the battery.
^ Remove the battery junction box (BJB) fuses 9 (50A) and 18 (50A).

3. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^ To install, tighten to 35 Nm (26 lb-ft).
^ Support the caliper using mechanic's wire.
4. Remove the brake pads from the brake caliper.
5. To install, reverse the removal procedure.