Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor

Material:

Removal and Installation





1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the 7 retainers and the LH splash shield.
^ To install, tighten to 10 Nm (89 lb-in).





3. Remove the output shaft speed (OSS) sensor
1 Disconnect the OSS electrical connector.
2 Remove the OSS sensor bolt.
3 Remove the OSS sensor.
^ To install, tighten to 12 Nm (9 lb-ft).





4. NOTE: When installing the sensor, lubricate the O-ring seal with clean transmission fluid.

Inspect the O-ring seal for nicks or cuts. Install a new O-ring seal as necessary.





5. To install, reverse the removal procedure.