C-Pillar Trim Panel

C-PILLAR TRIM PANEL

Exploded View

Part 1:

Part 2:

Removal and Installation

1. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.

Remove the safety belt guide cover by squeezing the height adjuster buttons and pulling the cover out at the bottom.







2. Remove the safety belt bolt.
- To install, tighten to 48 Nm (35 lb-ft).







3. Remove the quarter trim panel.
4. Position the rear door weatherstrip aside.
5. Remove the cover, the bolt and the C-pillar trim panel.
- To install, tighten to 7 Nm (62 lb-in).







6. To install, reverse the removal procedure.