Stabilizer Link: Service and Repair

Stabilizer Bar Link

Removal and Installation
1. Remove the wheel and tire.

2. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer bar link nut.

Remove the upper stabilizer bar link nut.
^ To install, tighten to 63 Nm (46 lb-ft).

3. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer link nut.

Remove the lower stabilizer bar link nut.
^ To install, tighten to 55 Nm (41 lb-ft).

4. NOTE: Inspect the stabilizer bar link ball joints and boots for wear. If necessary, install new parts.

Remove the stabilizer bar link.
5. To install, reverse the removal procedure.