Transaxle Support Insulator - LH

Transaxle Support Insulator - LH

Special Tool(s):

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the air cleaner. For additional information, refer to Fuel Delivery and Air Induction.
3. Using the special tool, support the engine.





4. Remove the 4 LH transaxle support insulator bolts.
^ To install, tighten to 48 Nm (35 lb-ft).
5. Remove the through bolt and the LH transaxle support insulator.
^ To install, tighten to 103 Nm (76 lb-ft).
6. Remove the 3 nuts and the LH transaxle support insulator bracket.
^ To install, tighten to 40 Nm (30 lb-ft).
7. To install, reverse the removal procedure.