Power Running Board (PRB)

POWER RUNNING BOARD (PRB)







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.

2. NOTE: If the power running board (PRB) cannot be extracted, extend the running board by hand.

Extend the PRB.

3. Disconnect the PRB motor electrical connector.







4. CAUTION: An assistant is required to hold the power running board (PRB) before removing the lower bolts.

NOTE: Only 3 bolts shown.

Remove the front PRB upper and lower bolts.
- To install, tighten to 23 Nm (17 lb-ft).







5. Remove the rear PRB upper and lower bolts and remove the PRB assembly.
- To install, tighten to 23 Nm (17 lb-ft).







6. To install, reverse the removal procedure.