60 Percent

SEAT BACKREST - THIRD ROW, 60 PERCENT

60 Percent Backrest (Part 1):

60 Percent Backrest (Part 2):

Disassembly and Assembly

All seats
1. Remove the third row 60 percent seat.
2. Remove the third row 60 percent seat backrest.
3. Remove the safety belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).

4. NOTE:
- Note the spring clip position for installation.
- Use care when releasing the spring clips. They can fall inside the backrest frame.

Remove the head restraint.
- Pull the trim cover material away from the head restraint guide to access the spring clips.
- Release the 2 spring clips by pushing on the side shown.
- Raise and remove the head restraint.







5. Release all the backrest trim cover J-clips.
6. Remove all the staples.







7. Release the hook-and-loop strip.

Manual seat

8. NOTE: Note cable routing for installation.

Remove the 2 screws and the manual latch handle and cable assembly.
- Route out the cable.

All seats
9. Remove the safety belt guide cover.

10. NOTE: The head restraint sleeve pins are not interchangeable. Note location for installation.

Reach up into the backrest and squeeze the head restraint guide ends together to release and pull the 2 head restraint guides out.

11. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the backrest foam pad.

Separate the hook-and-loop strips and invert the backrest trim cover to the row of hog rings.

12. Remove the row of hog rings.
13. Remove the trim cover.
- Route the safety belt webbing through the trim cover.

14. Remove the backrest foam pad.
15. Remove the nut, screw and support bracket.
16. Remove the outboard latch-to-cushion frame bolt and outboard latch.
- To install, tighten to 35 Nm (26 lb-ft).

17. Remove the 2 inboard latch-to-backrest frame bolts and the inboard latch.
- To install, tighten to 55 Nm (41 lb-ft).

18. Remove the 4 screws and the safety belt retractor cover.
19. Remove the safety belt retractor bolt.
- To install, tighten to 40 Nm (30 lb-ft)

20. Pinch to release the safety belt guide and remove the safety belt retractor.
- Route through the backrest frame.







21. Remove the 15 screws and the backrest support panel.
22. Remove the bolt and child safety seat tether anchor.
- To install, tighten to 15 Nm (11 lb-ft).







23. To assemble, reverse the disassembly procedure.