60 Percent
SEAT CUSHION COVER - FRONT, 60 PERCENTExploded View
Seat Backrest - Front, 40 Percent (Part 1):
Seat Backrest - Front, 40 Percent (Part 2):
Seat Cushion - Front, 40 Percent (Part 1):
Seat Cushion - Front, 40 Percent (Part 2):
Seat Cushion - Front, 60 Percent (Part 1):
Seat Cushion - Front, 60 Percent (Part 2):
Removal and Installation
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the 60 percent seat.
2. Release the cushion trim cover front and rear J-clips and hook-and-loop strips.
3. Remove the 2 cushion frames from the seat track.
- Remove the 8 cushion frame-to-seat track bolts.
- To install, tighten to 25 Nm (18 lb-ft).
- Release the 4 cushion frame rear clips and straps from the seat track and remove both cushion frames.
4. Release the 4 cushion trim cover retainer clips and remove the trim cover and foam pad from the cushion frames.
5. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the cushion foam pad.
Remove the cushion trim cover.
- Partially invert the cushion trim cover and separate the hook-and-loop strips.
- Remove the hog rings and separate the trim cover and foam pad.
6. To install, reverse the removal procedure.
7. Install the seat.