Seat Track - Manual

SEAT TRACK - MANUAL

Exploded View

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Removal and Installation

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the affected seat.
2. Remove the inboard and outboard seat track rails.
- Remove the 6 seat track rail-to-seat track nuts from the inboard and outboard seat track rails.
- To install, tighten to 30 Nm (22 lb-ft).

- Remove the inboard and outboard seat track rails.
- Release and separate the seat track adjust handle from the seat track rails.

- NOTE: Note the spring position for installation.

Disconnect the spring.

- Slightly bend the tab and detach the seat adjust handle from the inboard seat track rail.







3. To install, reverse the removal procedure.
4. Install the seat.