Seat Track - Power

SEAT TRACK - POWER

Exploded View

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Removal and Installation

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

NOTE:
- If a new driver seat module (DSM) has been installed, all seat and power tilt column (if equipped) soft stops must be reset. If a new seat track, recline motor or power tilt column has been installed, only reset the soft stops for that component being installed new. To reset the soft stops, refer to principles of operation. Principles of Operation
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All seats
1. Remove the affected seat.
2. Remove the seat backrest.
3. Remove the safety belt buckle pretensioner.
- Remove the tie strap.
- Disconnect the 2 electrical connectors.
- Remove the nut and safety belt buckle pretensioner.
- To install, tighten to 55 Nm (41 lb-ft).







4. Release the cushion trim cover front and rear J-clips and rear hook-and-loop strip.

Climate Controlled Seats

5. NOTE:
- Use care when removing the thermo-electric device (TED). The U-nuts can slip into the cushion frame.
- Note wiring harness routing for installation.

Remove the climate controlled seat TED.
- Disconnect the electrical connector.
- Detach the pin-type retainer and wiring harness.
- Remove the 2 screws.
- Route the wiring harness and remove the TED.







6. Release the 2 tabs and slide out the dual climate controlled seat module (DCSM).







7. NOTE: When installing a new DCSM, it is necessary to carry out programmable module installation (PMI).

If passenger seat, remove the DCSM.
- Cut and remove the wiring harness tie strap.
- Release the 2 locking wedges.
- Disconnect the 3 electrical connectors.







Driver memory seat
8. Remove the DSM.
- Disconnect the 5 electrical connectors.
- Release the 2 tabs and slide out the DSM.







All seats
9. Remove the cushion frame, foam pad and trim cover assembly from the seat track.
- Remove the 4 cushion frame-to-seat track bolts.
- To install, tighten to 25 Nm (18 lb-ft).

- Release the 2 cushion frame rear clips and straps from the seat track and remove the cushion frame.

10. Disconnect the seat track motor electrical connector.
- For 6-way power seat, disconnect the 3 motor electrical connectors.
- For memory seat, disconnect the 6 motor electrical connectors.

11. NOTE: Note wiring harness routing for installation.

Remove the wiring harness.
- Remove the 3 wiring harness bracket screws.
- Remove the tie strap and release the rear wiring harness bracket clip from the seat track.
- Separate the electrical connectors and wiring harness from the seat track.
- Route and remove the wiring harness and bracket.

12. To install, reverse the removal procedure.
13. Install the seat backrest.
14. Install the seat.