20 Percent

SEAT - SECOND ROW, 20 PERCENT







Removal

NOTE: The seat-to-floor bolts must be tightened in the sequence described in this procedure.

1. Fold both 40 percent seats to the E-Z entry position.

2. CAUTION: Use a screwdriver to pry beneath the attaching metal clips or damage to the cover may result.

Remove the 2 right side seat-to-floor bolt covers.

3. Remove the 2 right side seat-to-floor bolts.

4. CAUTION: Use a screwdriver to pry beneath the attaching metal clips or damage to the cover may result.

Remove the left side seat-to-floor bolt cover.

5. Remove the left side seat-to-floor bolt.
6. Position the 40 percent seats upright.

7. CAUTION: Use a screwdriver to pry beneath the attaching metal clips or damage to the cover may result.

Remove the 2 seat-to-floor front bolt covers.

8. CAUTION: Use a screwdriver to pry beneath the attaching metal clips or damage to the cover may result.

Remove the 2 seat-to-floor rear bolt covers.

9. Remove the 2 seat-to-floor front bolts.
10. Fold both 40 percent seats to the E-Z entry position.
11. Remove the LH seat-to-floor rear bolt and then the RH seat-to-floor rear bolt.
12. Remove the 20 percent seat from the vehicle.

Installation

NOTE: The seat-to-floor bolts must be tightened in the sequence described in this procedure.

1. Position the 20 percent seat into the vehicle.
- Align the locator pins to the holes in the floor.

2. Fold both 40 percent seats to the E-Z entry position.
3. Install the seat-to-floor bolts in the following sequence.
1 Install the RH seat-to-floor rear bolt.
- Tighten to 40 Nm (30 lb-ft).

2 Install the LH seat-to-floor rear bolt.
- Tighten to 40 Nm (30 lb-ft).

3 Install the 2 seat-to-floor front bolts.
- Tighten to 40 Nm (30 lb-ft).

4 Install the 3 right and left side seat-to-floor bolts (note, shoulder bolts do not tighten to seat brackets).
- Tighten to 40 Nm (30 lb-ft).

4. Install the 2 seat-to-floor rear bolt covers.
5. Install the 2 seat-to-floor front bolt covers.
6. Install the 2 right and 1 left side seat-to-floor bolt covers.
- To install, tighten to 40 Nm (30 lb-ft).

7. Check the active restraints.
- Make sure the safety belts and buckles are accessible to the occupants after installation.
- Make sure the safety belt retractor operates without excessive effort or binding.