Wheel Speed Sensor - Front

Wheel Speed Sensor - Front





Removal and Installation

1. NOTE: If equipped, turn the air suspension switch to the OFF position.

Remove the wheel and tire.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor harness retainer bolt and detach the retainers.
^ To install, tighten to 12 Nm (9 lb-ft).

4. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.

Remove the 2 caliper anchor bolts and position the caliper, pads and anchor plate aside.
^ Support the caliper with mechanic's wire.
^ To install, tighten to 200 Nm (148 lb-ft).
5. Remove the brake disc.
6. Remove the front wheel speed sensor bolt and the sensor.
^ To install, tighten to 18 Nm (13 lb-ft).
7. To install, reverse the removal procedure.