Fan Blade: Service and Repair

Cooling Fan











Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the cooling fan electronic clutch electrical connector.
3. Remove the nut and the cooling fan electronic clutch harness support bracket from the stud bolt.
^ To install, tighten to 13 Nm (10 lb-ft).
4. Release the cooling fan shroud position tab and rotate the shroud upwards until the lower tab locks into position.





5. CAUTION: Do not sideload the cooling fan clutch coil or the cooling fan clutch may be damaged.

Using the special tools, remove the cooling fan and clutch assembly.
^ To install, tighten to 55 Nm (41 lb-ft).
^ If servicing the cooling fan or cooling fan clutch, refer to Cooling Fan and Cooling Fan Clutch.





6. To install, reverse the removal procedure.