Steering Angle Sensor: Service and Repair

Steering Wheel Rotation Sensor





Removal and Installation
1. Disconnect the steering wheel rotation sensor electrical connector.
2. Remove the 2 bolts and the steering wheel rotation sensor.
^ To install, tighten to 3 Nm (27 lb-in).
3. To install, reverse the removal procedure.

4. NOTE: If the sensor is not calibrated after installation, a DTC will be set in the ABS module.

Calibrate the sensor in the following sequence:
1 Start the engine.
2 Rotate the steering wheel from lock to lock a minimum of 2 times.