Ride Height Sensor: Service and Repair

Suspension Height Sensor








Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the height senor harness from the sensor bracket.
3. Disconnect the height sensor electrical connector.
4. Disconnect the height sensor arm from the ball stud on the lower control arm.
5. Remove and discard the 2 height sensor bolts.
^ To install, tighten to 11 Nm (8 lb-ft).

6. NOTE: The RH and LH height sensor assemblies cannot be used on opposite sides of the vehicle.

To install, reverse the removal procedure.
7. Calibrate the LH and RH height sensors.