Part 1

Transmission

Assembly (Steps 1-13)











Disassembled Views

Disassembled Views (Part 1):

Disassembled Views (Part 2):

Disassembled Views (Part 3):

Disassembled Views (Part 4):

Disassembled Views (Part 5):

Disassembled Views (Part 6):

All vehicles
1. If removed, position the rear case roller bearing in the case.





2. Using the special tools, install the roller bearing.





3. Install the snap ring.





Rear wheel drive (RWD) vehicles
4. Using the special tools, install the rear case roller bearing in the case.





5. Install the roller bearing snap ring.





Four wheel drive (4WD) vehicles
6. Using the special tools, install the rear bearing spacer.





7. Install the rear bearing spacer snap ring.





All vehicles
8. Place the transmission in the vertical position.
9. Install the planet carrier hub and output shaft assembly.





10. Install the silver shim (caged bearing) on the planet carrier hub and output shaft assembly.





11. Position the park pawl pin into the case.





12. Position the park pawl into the case and push the park pawl pin in to hold the park pawl and spring in position.





13. Install the park pawl pin bolt.
^ Tighten to 35 Nm (26 lb-ft).