Selector Lever Knob
Selector Lever KnobVehicles Equipped With a 6R75 Transmission
Vehicles Equipped With a 6HP26 Transmission
Removal
1. NOTE: 6R75 transmission selector lever shown, 6HP26 similar.
Remove the PRNDL trim, console tray and cup holder insert.
2. Remove the screw and the console upper trim.
3. Remove and discard the RH selector lever knob cover.
1. Start at the bottom front only.
2. Move towards the top front and remove the cover.
4. Remove and discard the LH selector lever knob cover.
1. Start at the bottom front only.
2. Move towards the top front and remove the cover.
5. Remove and discard the RH selector lever knob screw.
6. NOTE: Verify the LH and RH knob body towers are present and not damaged.
Remove and discard the LH selector lever knob screw.
7. Disconnect the transmission control (TC) switch electrical connector and remove the selector lever knob.
Installation
1. Connect the TC switch electrical connector and install the selector lever knob.
2. Install a new LH selector lever knob screw.
3. Install a new RH selector lever knob screw.
4. NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
Install a new LH selector lever knob cover.
5. NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
Install a new RH selector lever knob cover.
6. Install the console upper trim and the screw.
7. Install the PRNDL trim, console tray and cup holder insert.
