Selector Lever Mechanism

Selector Lever Mechanism

Removal
1. Remove the instrument panel (IP) lower finish panel.

2. Remove the steering column lower shroud.
1. Remove the screws and the lower shroud.

3. Remove the steering column upper shroud.
4. Remove the IP cluster-to-shroud trim.

5. Remove the RH IP cluster trim screw.

6. Remove the LH IP cluster trim screw and pull the IP cluster trim from the IP.

7. If equipped, disconnect the in-vehicle temperature sensor connector.

8. Disconnect the dimmer switch electrical connector and remove the IP cluster trim.

9. Remove the upper IP cluster screws.

10. Remove the RH lower IP cluster screw.

11. Remove the LH lower IP cluster screw and position the IP cluster aside.

12. CAUTION: To prevent cable damage, do not apply force to the selector lever cable assembly between the steering column selector lever arm and the steering column bracket.

Disconnect the selector lever cable.

13. Remove the locking pin and the park lock cable (PLC).
1. Remove and discard the locking pin.
2. Disconnect the PLC.

14. Disconnect the transmission control (TC) switch electrical connector and the harness from the retaining clips.

15. Remove the selector lever bolt.

16. Remove the selector lever.

17. Remove the selector lever mechanism lower bolt.

18. Disconnect the brake shift interlock actuator (BSIA) electrical connector and remove the selector lever mechanism upper bolts and the selector lever mechanism from the vehicle.

19. Remove the BSIA from the selector lever mechanism.
1. Pull the BSIA override button.
2. Remove the BSIA screw.
3. Gently pry the clip up and remove the BSIA.

Installation
1. Install the BSIA onto the selector lever mechanism.
1. Pull the BSIA override button.
2. Align the selector lever tab into the BSIA.
3. Position and secure the BSIA with the clip.
4. Install the screw.

2. Install the selector lever mechanism into the vehicle, install the upper bolts and connect the BSIA electrical connector.
^ Tighten to 6 Nm (53 lb-inch).

3. Install the selector lever mechanism lower bolt.
^ Tighten to 6 Nm (53 lb-inch).

4. Install the selector lever.
^ Tighten to 18 Nm (13 lb-ft).

5. Connect the TC switch electrical connector and the harness into the retaining clips.

6. Install the locking pin and the PLC.
1. Connect the PLC.
2. Install a new locking pin.

7. CAUTION: To prevent cable damage, do not apply force to the selector lever cable assembly between the steering column selector lever arm and the steering column bracket.

Connect the selector lever cable.